Simultaneous determination of CFC-11, CFC-12 and CFC-113 in seawater samples using a purge and trap gas-chromatographic system.

We have optimized the analytical parameters of a homemade instrument for the simultaneous measurement of the chlorofluorocarbons CCl(2)F(2) (CFC-12), CCl(3)F (CFC-11) and C(2)Cl(3)F(3) (CFC-113) in seawater. Seawater samples are flame sealed into 60 ml glass ampoules avoiding any contact with the atmosphere and stored in cold, dark condition until analysis. In the laboratory, after cracking the ampoule in an enclosed chamber filled with ultra-pure nitrogen, the seawater sample is transferred to a stripping chamber, where ultra-pure nitrogen is used to purge the dissolved CFCs from the seawater. The extracted gases are then cryogenically trapped, subsequently the trap is isolated and heated and the CFCs are transferred by a carrier gas stream into a precolumn and then are separated on a gaschromatographic packed column. To separate adequately CFC-12 from N(2)O, during the early part of the chromatographic run, the gas stream passes through a molecular sieve, which is then isolated and backflushed. The CFCs are detected on an electron capture detector ((63)Ni ECD). After a careful choice of the experimental conditions, the performances of the system were evaluated. The detection limits for seawater samples are: 0.0081 pmol kg(-1) for CFC-12, 0.0073 pmol kg(-1) for CFC-11 and 0.0043 pmol kg(-1) for CFC-113. The reproducibility of replicate samples lies within 5% for the three CFCs. The system has been successfully employed for CFC measurements in seawater samples collected in the Ross Sea (Antarctica) in the framework of the Italian Antarctic research project.

Multivariate optimization of an axially-viewed inductively coupled plasma multichannel-based emission spectrometer for the analysis of environmental samples.

An experimental design procedure was applied to optimize the operating conditions of an axially-viewed inductively coupled plasma emission spectrometer instruments equipped with echelle optics with cross dispersion and charge transfer device. The multivariate effect of carrier gas flow rate and r.f. power on several analytical figures was investigated and discussed. Both ultrasonic and pneumatic nebulization were used. For the final choice of the optimum, different criteria were taken into account, mainly plasma robustness, instrumental precision, analyte and background net emission, detection limits and signal-to-background ratios. It was found that the use of moderate power (1100W) and mean carrier gas flow rate (0.75 L/min) allows to obtain sufficient plasma robustness, satisfactory precision, and excellent signal-to-background ratios and limits of detection, favorable for ultratrace element determinations in environmental matrices.

Determination of lead in bone tissues by axially viewed inductively coupled plasma multichannel-based emission spectrometry.

A new procedure for determining low levels of lead in bone tissues has been developed. After wet acid digestion in a pressurized microwave-heated system, the solution was analyzed by inductively coupled plasma multichannel-based emission spectrometry. Internal standardization using the Co 228.615 nm reference line was chosen as the optimal method to compensate for the matrix effects from the presence of calcium and nitric acid at high concentration levels. The detection limit of the procedure was 0.11 microg Pb g(-1) dry mass. Instrumental precision at the analytical concentration of approximately 10 microg l(-1) ranged from 6.1 to 9.4%. Precision of the sample preparation step was 5.4%. The concentration of lead in SRM 1486 (1.32+/-0.04 microg g(-1)) found using the new procedure was in excellent agreement with the certified level (1.335+/-0.014 microg g(-1)). Finally, the method was applied to determine the lead in various fish bone tissues, and the analytical results were found to be in good agreement with those obtained through differential pulse anodic stripping voltammetry. The method is therefore suitable for the reliable determination of lead at concentration levels of below 1 microg g(-1) in bone samples. Moreover, the multi-element capability of the technique allows us to simultaneously determine other major or trace elements in order to investigate inter-element correlation and to compute enrichment factors, making the proposed procedure particularly useful for investigating lead occurrence and pathways in fish bone tissues in order to find suitable biomarkers for the Antarctic marine environment.

Metal speciation and environmental impact on sandy beaches due to El Salvador copper mine, Chile.

Several coastal rocky shores in northern Chile have been affected by the discharges of copper mine tailings. The present study aims to analyze the chemical speciation of heavy metals in relation to the diversity of sessile species in the rocky intertidal benthic community on the northern Chilean coast, which is influenced by the presence of copper mine tailings. In particular, the chemical forms of Cd, Cu, Fe, Mn, Ni, Pb and Zn in beach sediment samples collected in the area influenced by El Salvador mine tailings were studied using a sequential chemical extraction method. In general, all the elements present a maximum concentration in the area near the actual discharge point (Caleta Palito). With regard to Cu and Mn, the concentrations range between 7.2-985 and 746-22,739 microg/g respectively, being lower than background levels only in the control site of Caleta Zenteno. Moreover, the correlation coefficients highlight that Fe, Mn and Ni correlate significantly and positively in the studied area, showing a possible common, natural origin, whilst Cu shows a negative correlation with Fe, Mn and Ni. It could be possible that Cu has an anthropogenic origin, coming from mining activity in the area. Cd, Fe, Mn, Ni, Pb and Zn are mostly associated with the residual phase, whilst Cu presents a different speciation pattern, as resulted from selective extractions. In fact, Cu is highly associated with organic and exchangeable phases in contaminated localities, whilst it is mainly bound to the residual phase in control sites. Moreover, our results, compared to local biological diversity, showed that those sites characterized by the highest metal concentrations in bioavailable phase had the lowest biodiversity.

Determination of ultratrace elements in natural waters by solid-phase extraction and atomic spectrometry methods.

A study was carried out on the preconcentration of ultratrace amounts of cadmium, lead, manganese, copper and iron from high-salinity aqueous samples and determination by atomic spectrometry methods. Sample volume, amount of resin, loading flow rate, and elution volume were optimized in order to obtain the simultaneous preconcentration of all the analytes. Quantitative recoveries were obtained by using 200 mg of iminodiacetic resin with a loading flow rate of 2 mL min(-1), elution volume of 3 mL and sample volume of 50-450 mL. Only copper in seawater samples was not completely retained by the resin (60-70% recovery), due to unfavorable competition of iminodiacetic-active groups with organically bound metal.To quantify the metals in the eluates, two atomic spectrometry techniques were compared: electrothermal atomization atomic absorption spectrometry (ETAAS) and inductively coupled plasma-optical emission spectrometry (ICP-OES) with simultaneous CCD detection system. Both techniques are suitable for sample analysis with detection limits of 1.0, 4.7, 3.3, 6.8, and 53 ng L(-1) using ETAAS and 12, 122, 3.4, 17, and 21 ng L(-1) using ICP-OES for Cd, Pb, Mn, Cu, and Fe, respectively. Relative standard deviations of the procedures ranged from 1.7 to 14% at the sub-microg L(-1) concentration level. The accuracy of both methods was verified by analyzing various certified reference materials (river water, estuarine water, coastal and off-shore seawater).

Determination of trace level of selenium and mercury in photographic emulsions by atomic spectroscopy techniques.

Trace level of selenium and mercury in photographic emulsion are used to improve photographic properties. The presence of silver halide in photographic emulsion does not allow the application of the most common analytical methods such as Hydride Generation Atomic Absorption Spectrometry (HG-AAS) and cold vapour Atomic Absorption Spectrometry (CV-AAS). Besides, silver removal was not quantitative, leading to a significant loss of the analytes and low reproducibility. The present work suggest the use of inductively coupled plasma Atomic Emission Spectrometry (ICP-AES) equipped with Ultrasonic Nebulizer (USN) for direct aqueous samples analysis at microgram l-1 level (d.l. 5.1 ppb for Hg and 6.1 ppb for Se).

Inductively coupled plasma optical emission spectrometric determination of trace elements in sediments after sequential selective extraction: effects of reagents and major elements on the analytical signal.

The interfering effects due to the reagents and matrix elements associated with a four step sequential extraction procedure on ICPOES determination of trace elements were investigated in a systematic way. The emission lines were selected in order to include the most interesting elements for environmental studies (Zn, Pb, Ni, Cr, V and Cu) and the concentrations ranged according with the values occurring in the real samples. In order to distinguish between chemical and physical interfering effects, the Mg 280.270-Mg 285.213 line intensity ratio was measured, in each condition. Both pneumatic and ultrasonic nebulization were considered for comparison. It was found that both the elements which constitute the sample and the reagents which are added during the sample preparation steps significantly influence the emission intensity of all the analytes, depending on the analytical concentration and the nebulization system. Generally, the signal variations were higher with ultrasonic nebulization. Concerning the interference mechanism, it was found that the effect of the major elements (Na, K, Mg, Ca, Al and Fe) is essentially related to a change of the aerosol generation and transport processes. Differently, acetic acid, ammonium acetate and hydroxylamine hydrochloride significantly improved the plasma excitation conditions, depending on their concentration. A change of the sample introduction efficiency due to the presence of these reagents was also evident. On the contrary, the effect of hydrochloric and nitric acid emerged to be related only to the processes occurring in the sample introduction system.